IEYTD 2 | Mission 3

Follow red cables near lasers to a statue of an empty hand.

Grab the sphere from another hand statue on the left side of the first floor and move it to the empty hand on the top floor (pull it through gaps in the lasers!)

Retrieve flashlight from the cardboard box it lands on; socket into mouth for ease

Use the crank to descend down to the desk. Descend until the crank goes away

Pull out lower right drawers to unlock the rolltop. Each drawer has a red square on its side that lines up with a hole in the side of the desk

Open central desk area rolltop

Open the bottom-left drawer
1) Grab the xacto knife off of the desk and socket the back end of it into the lock on the massive bottom-left drawer of the desk
2) Rotate the dial inside the drawer until the leftmost triangle puzzle piece (in the center of the desk) displays a corner of an upside-down triangle

Open the left door
1) Toss aside cutting board and open sliding door in the desk’s surface
2) Retrieve small wooden wheel from pegboard wall behind desk
3) Socket the wheel into gears in desk surface, turn clockwise until it recedes into desk and stops responding
4) Find the screwdriver in the left cabinet of the now-raised back of desk
5) Socket the back of the screwdriver into left door of main level of desk
6) Rotate dial inside until central triangle puzzle piece rotates to display a hammer and chisel image

Open the right door
1) Open the bottom of the two small left drawers very slightly
2) Telekinesis xacto knife into open slit in the drawer to cut the tripwire inside
3) Find the chisel in the drawer and socket it backwards into the right door of the desk
4) Grab the screwdriver from the left door and use it to remove false wall panel inside of right door (loosen two screws)
5) Turn dial behind false wall until the right triangle puzzle piece rotates to display an inverted piece of a triangle

Completing central puzzle image will open center door, revealing mask

Touch mask to cause it to open

Around this time, the handler will lower an adorable little case on a wire with a tracking device inside; grab the case and remove the device

Remove the yellow circle on the left-hand side of the mask

Use xacto knife to cut wires on the right-hand side of the mask

Remove the square chip that was between the wires

Place the tracking device where the square chip was

Place the square chip back overtop of the tracking device

Grab the soldering gun from the pegboard wall behind desk

Solder all three wires around square chip back together

Replace the yellow circle to the left side of the mask, causing it to close

A guard will be heard approaching after the mask closes back up

Put the mask on your face

Use the voice changer in top-center of desk to select the Fabricator’s voice and press “Play” to trick guard (wait a few moments for Fabricator’s voice to play and for him to leave)

Alternatively, grab a dart from the top-left drawer and TK it into the crossbow of the bear up on the top floor; the bear will then shoot the guard

Doff mask and place it back on its stand

Use the crank when it reappears to go up and out of the level.